Stainless steel chimneys
Stainless steel chimney systems are versatile and can work with any heating equipment. They are also easy to install and take up minimal space. Due to their modularity (the maximum pipe length is 1 meter), the components can be used to assemble a chimney system of any configuration.8
SPC “DAnI Ukraine” LLC offers chimneys made of acid-resistant and heat-resistant stainless steel. Thanks to this, our products have a wide range of applications – from condensing gas boilers to fireplaces and wood stoves. With this in mind, it is important to select the right wall thickness for the stainless steel pipe. For gaseous fuels, a wall thickness of 0.5-0.6 mm is recommended, while for solid fuels, 0.8 or 1 mm, depending on the flue gas temperature.
Single-walled chimneys
Single-walled stainless steel chimneys are designed for lining existing brick channels. They reliably protect the existing chimney from the effects of aggressive condensation generated by modern heating appliances. Single-walled systems are used for laying the flue duct only inside the heated room, or as inserts into the existing brick chimney of a gas boiler, fireplace, stove, etc.
Double-walled chimneys
Insulated chimneys are used for outdoor chimneys (attached chimneys, part of the chimney above the roof).
Pre-insulated pipes consist of an inner and an outer pipe. Between them there is a pressed mineral wool insulation material based on basalt rocks 30-35 mm thick, which can withstand temperatures up to 1000°C and has low thermal conductivity. This minimizes the formation of aggressive condensation. Also, due to the insulation, double-walled chimneys keep the temperature of flue gases as high as possible, which prevents a decrease in draft in winter.
Chimney design scheme
Roof
The main function of the chimney cap is to protect against atmospheric precipitation, and it also serves as a fireplace decoration.
Deflector
The deflector itself increases the draft by deflecting air flows. The wind hits an obstacle, and a low-pressure zone appears in front of the chimney. This is how the draft is enhanced.
Studies have shown that when a chimney deflector is used, the efficiency of a chimney increases by as much as 20%. It also protects chimneys well from snow, rain and plant debris that can be carried by the wind. Moreover, the deflector works well in any conditions – no matter how and where the wind blows. It also serves as a decoration for your chimney system.
Increase the efficiency of your chimney with a deflector.
Tees 90° 45°
Tees are designed to connect the heater to the chimney. An inspection plug or condensate drain can be installed in the lower part of the tees.
The chimney is inspected and cleaned through the tee.
A wide range of tees for different chimneys.
Reducing transition
Reducing adapter is an element used to connect two single-walled parts of a chimney system of different diameters. If it is necessary to change the diameter of the flue duct from smaller to larger, or vice versa, an adapter is installed at the joints.
It is made of stainless steel to customer specifications.
Inspection with external hatch
It serves as a support for the chimney structure. It is used to clean and inspect the chimney.
Pipe (Sleeve)
The chimney pipe is the main element of the chimney system, through which
the removal of combustion products from your heating device (boiler, furnace or fireplace). It is intended for lining of existing brick channels. Protects the chimney from condensation, soot, thereby preventing its destruction. The service life is increased.
Made of acid-resistant stainless steel.
Pipe (Sleeve) Oval
The oval section pipe is designed for lining brick channels.
It is made of stainless steel to customer specifications.
Stainless steel box
A rectangular tube is used for lining brick channels.